Ultramarines Second Company

Ultramarines 2nd Company

This is a break down of my Ultramarines Second Company that I am currently working upon.  I started collecting this Company when I purchased the Armageddon Battle Company box set back in 2008.  Unfortunately, due to time constraints back then, only one squad of marines was finished and another two squads were ready for paint.  Everything was then packed up and put into the attic to gather dust!

Ultramarines 2nd company

So, 3 squads needed to be moved onto 32mm bases which I have purchased. I also have since found 1 plastic dreadnought, which I had ”battle damaged” back then. I’m not entirely keen on it, but I shall keep on with it. I do seem to remember purchasing a bunch of Ultramarine shoulder pads, alongside doors for each of the 9 rhino vehicle and a FW dreadnought – the one with the awesome tyranid banner pole. I shall be doing my best to locate these things, as I hate to think of wasting the money!

For the other marines, I am currently removing arms and weaponry ready to get glued into position. I will be priming and painting in subassemblies, but also using a different paint scheme!! Something a bit brighter and with red gun casings.

So *hopefully* with both dreadnoughts, I do have 8 rhinos and one razorback – for the life of me I can’t find my old original razorback with the metal turret! Alongside those, I have my old Space Wolf predator annhilator as well to paint up in the Ultramarines scheme!

I will be be painting some of these up on my Twitch stream, so do make sure to swing by!

author avatar
Badger
I've been painting on and off since 1988, and finally dedicating a blog to it!

Share:

Picture of Badger

Badger

I've been painting on and off since 1988, and finally dedicating a blog to it!
On Key

Related Posts

Horus heresy legiones astartes battle group unbixing title card

Horus Heresy Legiones Astartes Battle Group

Unboxing Horus Heresy Legiones Astartes Battle Group Introduction Here we finally have the unboxing of the Legiones Astartes Battle Group for the Horus Heresy! This blog post is unfortuantely arriving later than planned as the entire website had to go

Featured image of the 3d printing studio blog post title card

Furnishing the new 3D Printing Studio

Let’s begin! This will be a relatively short post on furnishing the 3d printing studio, so without further ado, let us begin. As you will know from our previous post on building the 3d printing and paint studio, we now

Organising the studio trying to harness the chaos title card

Chaos to Order: Studio Organisation

In the beginning, there was chaos… Studio organisation In this post, we are going to go over the final sort of, unpacking and studio organisation. I doubt we will fully get things as we want them, but we shall get

Shopping Basket
Scroll to Top
Verified by MonsterInsights